Aqua PRO 53011-0 빠른 시작 매뉴얼

{카테고리_이름} Aqua PRO 53011-0에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua PRO 53011-0 2 페이지. Automatic pool cover pump

페이지 인쇄

Quick Start Guide

Automatic Pool Cover Pump

YOU WILL NEED:

Tools:

Screw Driver

Wrench

Materials:

Garden Hose

Sump Pump

Discharge Hose Kit

Connecting a 1-1/4 in. hose kit

If you would prefer to use a 1-1/4 in. hose kit (not included)

in order to pump water away more quickly.

Securely attach the hose kit (not included) to the adaptor.

WARNING: Secure the discharge hose before plugging in

the pump. An unsecured discharge hose may "whip"

possibly causing personal injury, and/or property damage.

Model: 53011-0

Safety Goggles

Installing the adaptor and base

Attach the adaptor to the pump outlet.

NOTE:Be sure the anti-airlock hole is upward.

Install the pump to the base.

Operating the pump

Place the pump on the pool cover or any place that you

would like to remove water. And plug the pump power

plug into a 115V outlet, protected with a 10 AMP fuse

or circuit breaker.

NOTE: The pump will not start working unless water

level is over 2 in.

CAUTION: This hole is for anti-airlock purposes only.

Leakage of air or water is normal and necessary.

DO NOT REMOVE OR PLUG THIS HOLE!

Read your manual for installation, operation, and safety information.

This guide neither supplements nor replaces the Owner's Manual.

anti-airlock hole

is upward

adaptor

base

Connecting a 3/4 in. garden hose

Attach a garden hose with a 3/4 in. garden hose thread

(not included) to the adaptor.

NOTE: Be sure the 3/4 in. garden hose thread connector

has a rubber gasket to minimize water leaks.

NOTE: The larger the inside diameter and the shorter the

length of hose, the less pressure that is lost (or the

larger the flow rate).

NOTE:

This pump is fully automatic in operation.

If the water level is over 2 in. , the water

detector senses water. Then the control

system built in the pump automatically

starts the pump and the pump continues to

run until water is pumped down to 3/8 in.

deep, and then it stops. If the water level is

lower than 2 in., the pump will not start.