Aqua PRO ECO900 설치 및 사용자 설명서 - 페이지 15

{카테고리_이름} Aqua PRO ECO900에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua PRO ECO900 20 페이지. Swimming pool heat pump

VII.

Testing

Inspection before use

A. Check installation of the entire heater and pipe connections

according to the pipe connecting drawing;

B. Check the electric wiring according to the electric wiring diagram;

and grounding connection;

C. Make sure that the main heater power switch is off;

D. Check the temperature setting;

E. Check the air inlet and outlet.

Trial

A. The user must Start the water pump before the heat pump, and

turn off the heat pump before the water pump, or the heat pump will

be damaged;

B. The user should start the water pump, and check for any leakage

of water; Power on and press the ON/OFF bottom of the heat

pump, and set suitable temperature in the thermostat.

C. In order to protect the pool heat pump, the heater is equipped with

a time lag starting function, when starting the heater; the blower will

run 1 minute earlier than the compressor;

D. After the pool heat pump starts up, check for any abnormal noise

from the heater.

VIII.

1. Attention

A. Set proper temperature in order to get comfortable water

temperature; to avoid overheating or overcooling;

B. Please don't stack substances that can block air flow near inlet or

outlet area, or the efficiency of the heater will be reduced or even

stopped;

C. Please don't put hands into outlet of the swimming pool heater,