Aqua Pulse Spas Byron Luxury Spa 시작 지침 - 페이지 3
{카테고리_이름} Aqua Pulse Spas Byron Luxury Spa에 대한 시작 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Pulse Spas Byron Luxury Spa 5 페이지.
페이지 인쇄BYRON LUXURY SPA HOW TO BALANCE THE WATER
Note: When balancing the water in your spa you must wait 4 hours between adding each chemical.
FREE CHLORINE / GRANULAR CHLORINE ideal reading is 1-3ppm.
Each week you test the free chlorine / granular chlorine it should be reading 0ppm this is normal.
If you're reading is
lower than 1ppm
Chlorine.
Use a bucket and scoop some of the spas water into the bucket until it is roughly ¾ full, then add the
granular chlorine to the bucket of water and stir (avoid contact with your skin), after 60 seconds pour the water
from the bucket into the spa and run jet 1 for 5 minutes.
Do not put any of the chlorine granules left in the bucket into the spa they need to be thrown out.
Chlorine granules will damage your spas acrylic and parts, which will void their warranty.
Note: GRANULAR CHLORINE IS COROSIVE. Be careful not to contact yourself or the spas acrylic, cabinet, head
rests or hardcover with the chlorine as it will cause damage. We recommend you remove the spas headrest prior
to using the granular chlorine and replace them the next day to avoid discolouration.
If your reading is
higher than 1ppm do not add any granular
TOTAL ALKALINITY ideal reading is 80-120ppm.
If your reading is
lower than 80ppm
Alkalinity Increaser #4.
26g will raise the Total Alkalinity by 10ppm.
Do not use more than 28g in one day if you are making the adjustment from a 3 in 1 test strips reading.
Accurate pool or spa store readings can apply the recommended dose in one day, test strips reading need to be
retested between doses.
Use a bucket and scoop some of the spas water into the bucket until it is roughly ¾ full, then add the Alkalinity
Increaser #4 to the bucket of water and stir (avoid contact with your skin), once dissolved pour the water from the
bucket into the spa and run jet 1 for 5 minutes.
If you're reading is
higher than 120ppm
pH Reducer #6.
26g will lower the Total Alkalinity by 10ppm.
Do not use more than 42g in one day if you are making the adjustment from a 3 in 1 test strips reading.
Accurate pool or spa store readings can apply the recommended dose in one day, test strips reading need to be
retested between doses.
Use a bucket and scoop some of the spas water into the bucket until it is roughly ¾ full, then add the pH Reducer
#6 to the bucket of water and stir (avoid contact with your skin), once dissolved pour the water from the bucket
into the spa and run jet 1 for 5 minutes.
Visit: www.aquapulsespas.com.au
raise the free chlorine / granular chlorine by adding
raise the total alkalinity by adding
lower the total alkalinity by adding
chlorine.
48g
of
Granular