Allied Telesis AT-9812T V2 빠른 설치 매뉴얼 - 페이지 7

{카테고리_이름} Allied Telesis AT-9812T V2에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-9812T V2 10 페이지. At-9800 series switch

Quick Install Guide

C613-04038-01 REV H

Configuring the Switch

Some configuration is necessary to enable the advanced switching capabilities

of the switch. The switch can be configured via the Command Line Interface

(CLI) or Graphical User Interface (GUI).

Using the CLI to configure a switch

Connect a terminal or PC to RS-232 (ASYN0)

Using the supplied RS-232 DB9 straight-through cable, connect your

terminal or PC to the RS-232 Terminal Port on the switch's front panel.

Set the communication parameters

Set the communication parameters on your terminal or terminal emulation

program to:

•

Baud rate: 9600

•

Data bits: 8

•

Parity: None

•

Stop bits: 1

•

Flow control: Hardware

Check the power supply

Ensure that the On/Off switch (AC models) or Run/Standby switch (DC

models) is in the On or Run position and that the switch is receiving power

(Power LED lights green).

After the switch has booted, the log in prompt appears. If the log in prompt

doesn't appear, press [Enter] two or three times.

When the switch boots for the first time it automatically creates an account

with manager privileges. The account has the log in name "manager" and

the password is "friend".

At the log in prompt, enter the log in name and password.

Password: friend

The command prompt appears and you can now configure the switch

using the command line interface.

Change the password as soon as possible. Leaving the manager account with

the default password is a serious security risk. Make sure you remember the

new password as there is no way to retrieve it if it is lost.

Use the following command to change the account password:

set password

To display a list of help topics, enter:

help

To display help on a specific topic, enter:

help topic