Allied Telesis AT-9812TF 빠른 설치 매뉴얼 - 페이지 7

{카테고리_이름} Allied Telesis AT-9812TF에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-9812TF 12 페이지. At-9800 series
Allied Telesis AT-9812TF에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (11 페이지)

페이지 인쇄

1. Configuring the Switch

Quick Install Guide

C613-04038-01 REV F

10. Connect the Redundant Power Supply (Optional)

AC models of AT-9800 Series switches have a Redundant Power Supply

(RPS) connector on their rear panel.

AT-9812TF and AT-9816GF AC models can be used with AT-RPS8000 RPS

systems, while AT-9812T and AT-9816GB AC models can be used with

AT-RPS9000 systems.

RPS systems can be purchased separately, contact your authorised Allied

Telesyn distributor or reseller for more information.

11. Install GBICs

Any combination of copper and fibre GBICs can be installed in the

following AT-9800 Series switches:

•

AT-9812T

•

AT-9812TF

•

AT-9816GB

For the AT-9816GF, up to fourteen 1000BASE-T GBICs can be installed. The

actual number depends on the number of fibre GBICs also installed.

Table 1 on page -7 lists the number of 1000BASE-T GBICs that can be

installed in the AT-9816GF for various copper/fibre combinations.

Table 1: GBIC configurations for the AT-9816GF.

Number of fibre GBICs installed

4 or 5

10 or 11

Slide the GBICs into the GBIC slots. Press each GBIC firmly into place.

A range of GBICs have been tested and approved for use with AT-9800 Series switches,

contact your authorised Allied Telesyn distributor or reseller for more information, or

visit www.alliedtelesyn.co.nz/support/at9800.

RX and TX terminal locations on SC fibre GBIC ports are the reverse of RX and TX

terminal locations on fixed SC fibre ports. When looking at an SC fibre GBIC from the

front, the RX terminal is on the left and the TX terminal is on the right.

Maximum number of 1000BASE-T GBICs that

can be installed