Allied Telesis AT-9816GF 빠른 설치 매뉴얼 - 페이지 5
{카테고리_이름} Allied Telesis AT-9816GF에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-9816GF 11 페이지. At-9800 series
Allied Telesis AT-9816GF에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (12 페이지)
페이지 인쇄
Quick Install Guide
Figure 1: AT-9816GF front panel and rear panel with AC power inlet.
1
2
9
10
AC SUPPLY DATA
HZ
~
100-120/200-240
50/60
Input Vdc
+3.3
+5
+12
R.P.S.
INPUT
CLASS 1
LASER
AC Power
AT-RPS8000 RPS Connector
C613-04038-01 REV D
5.
Install CAM (Optional)
If you purchased a Content Addressable Memory (CAM) module, install it
now by following the instructions in the CAM Quick Install Guide.
The CAM Quick Install Guide can be found on the AT-9800 Series
Documentation and Tools CD-ROM, or can be downloaded from
www.alliedtelesyn.co.nz/support/at9800/.
6.
Place the switch in its operating location
If installing the switch in a rack:
•
Remove the rubber feet
•
Attach the rack-mounting brackets
•
Mount the switch in the rack
7.
Apply AC power to the switch (for AC models)
Plug the power cord into the AC power connector on the switch's rear
panel. The Fault LED should flash for approximately 10 seconds as the
switch runs internal tests.
If the LED continues to flash or remains lit, refer to the AT-9800 Series
Hardware Reference for troubleshooting information.
1000BASE-X GBIC
3
4
5
11
12
13
AMPS
4/2
A Max
13
8
1
8.
Apply DC power to the switch (for DC models)
Read the Safety and Statutory Information booklet before connecting a DC
power supply. A copy of this booklet is included with each switch. It is also
included on the Documentation and Tools CD-ROM, or can be
downloaded from www.alliedtelesyn.co.nz/support/at9800/.
6
7
8
14
15
16
PORT ACTIVITY
AT-9816GF
L /A
L /A
L /A
L /A
LINK / FULL DUP
ACTIVITY
Multi-Layer Gigabit Switch
LINK / HALF DUP
ACTIVITY
GBIC
GBIC
L /A
ENABLED
DISABLED
FAULT
RS-232
TERMINAL PORT
1
2
3
4
5
6
7
8
ASYN0
L /A
GBIC
L /A
GBIC
9
10
11
12
13
14
15
16
COMPACT FLASH
ACTIVITY
Compact FLASH
5
STATUS
FAULT
RPS
RESET
PWR