DFI EC102-XNX 사용자 설명서 - 페이지 20

{카테고리_이름} DFI EC102-XNX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DFI EC102-XNX 20 페이지. Vision embedded system

Chapter 3 - First-time Use & Maintenance

X First-time Use

1. Check and ensure all the external system power supplies are turned off.

2. Install the Micro USB2.0 cable to OTG connector.

3. Press and hold on the Recover button.

4. Connect the power cord to the box PC.

X Force Recovery Mode

USB 3.l/OTG port can be used to re-program NVIDIA® Jetson NANO /Xavier NX by using the

other host system running NVIDIA Jetpack, as the procedure described below.

1. Power off the system. Ensure the system power must be completely OFF, instead of staying

in the suspend mode or the sleep mode.

2. Connect a USB cable from OTG USB port to the other host system which will be used to re-

program the new system file into NVIDIA® Jetson Nano/ Xavier NX.

3. Press and hold down Force Recovery Button and then power on the carrier board.

4. After three seconds, release Force Recovery Button.

5. NVIDIA® Jetson Nano/Xavier NX will show up on the USB list of the host system as a new

NVIDIA target device.

6. After the system software is updated successfully, please ensure to power off the system. A

clean power-on will then revert OTG port back to the host mode.

User's Manual | EC102-XNX

Chapter 3

First-time Use & Maintenance