Aqua Science PURE MAX 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Aqua Science PURE MAX에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Science PURE MAX 10 페이지. 4 and 5 stage models

페이지 인쇄

A q u a S c i e n c e A Z . c o m

Solutions For Life

IMPORTANT: Before installing this reverse osmosis system, make

certain your water supply complies with the following operating speci-

fications. Failure to do so may reduce the effectiveness of the system

and will void the warranty.

SPECIFICATIONS

Thin Film Composite Membrane:

Feed Water Pressure:

Temperature Range:

TDS (Total Dissolved Solids):

Maximum Hardness †:

Sulfide, Iron and Manganese:‡

Chlorine in Water Supply:

pH Limits:

Turbidity:

†

If the hardness of your water is above 10 gpg (171mg/l), lime scale

will build up rapidly on the membrane. Scale buildup will plug the

membrane and make the system ineffective. We do not recommend

these reverse osmosis systems to be used with water in excess of 10

gpg (171mg/l) hardness.

‡A maximum total level of approximately 0.01 ppm sulfide, iron or

manganese is permissible. Should your water exceed this, see your

local dealer to reduce these substances in your water.

PARTS INCLUDED:

Pre-assembled and leak tested filter system (mounting bracket,

membrane housing, membrane, pre-filter housings, pre-filter cartridges

and post-filter).

* Reverse Osmosis Membrane

* Inlet supply adaptor

* Feed Tubing (1/4-inch)

* Tank valve

C A L L F O R S E R V I C E 4 8 0 - 8 9 4 - 0 7 7 0

TFC

40 to 80 psi

40-100°F

2000 ppm

10 gpg (171 mg/l)

0 ppm <0.1 ppm

Less than 2 ppm

3-9

11 NTU Average

SYSTEM DIMENSIONS

Overall Dimensions:

Weight:

Tank Dimensions

Tank Capacity Max:

Tank Air Pressure Empty

NOTE:

*Storage Tank

•Your water must be within required limits for satisfactory operation. If not,

*Drain saddle

your membrane life may be shortened and your warranty will be voided.

•This reverse osmosis system will not protect against disease-causing

*Tank Tubing (3/8")

bacteria or remove naturally-occurring harmless bacteria.

*Faucet Tubing (3/8")

• Install on cold water line only.

• Do not use wicking or sealer to fitting connections into the cap of the

filter. Plumber tape is recommended.

• Make certain that installation complies with all state and local laws and

regulations.

• The replacement cartridges and reverse osmosis membrane

included with this system have limited service lives. Changes in

taste, odor, and color of the water being filtered indicate that the

cartridge should be replaced (see Replacing the Pre- and Post-Filters,

and Replacing the Membrane).

• After prolonged periods of non-use (such as during a vacation) it is

recommended that the system be flushed for 5 minutes and the tank

drained before it is used.

• A drinking water cartridge may contain carbon fines (very fine black

powder). After installation, flush the system for 5 minutes to remove the

carbon fines before using the water.

• It is recommended that you run the tap at least 20 seconds prior to using

water for drinking or cooking purposes.

• The contaminants or other substances removed or reduced by this water

treatment device are not necessarily present in your water.

14" W x 5 1/2" D x 17" H

17.3 lbs. (dry)

10" Dia. x 14" H

2.8 Gallons

7 to 10psi