DFI KS070-AL 설치 매뉴얼 - 페이지 2
{카테고리_이름} DFI KS070-AL에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DFI KS070-AL 19 페이지. 7 inch touch panel pc
DFI KS070-AL에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지)
페이지 인쇄
Panel
Top View
Bottom View
Grounding
Notes on Power Management Settings:
1.
AT Mode: The system powers on when power is applied.
2.
ATX Mode: The system powers on via the power button or the auto power-on setting in the BIOS.
3.
IGN Mode: The system powers on via the ignition control with settings of on/off delay in the
BIOS, plus low-voltage protection (i.e. the system will not power on if the car battery's voltage is
below 10.5, 21V and 42V for 12V input, 24V and 48V input respectively). Note that for this mode
to work, please switch the AT/ATX mode to ATX. Also note this mode is not available for systems
with a DC-in jack (optional).
Front OSD Functions
Backlight or Power
on/off
Notes on OSD Settings:
1. System Power On/Off: Press the Backlight on/off button for 3 seconds.
2. Light Sensor On/Off: Press the Brightness up arrow for 3 seconds.
3. OSD Lock/Unlock: Press the Brightness down arrow for 3 seconds.
4. Both the Status LED (on the box module) and Power LED (on the front OSD) will flash when the
power on/off delay has been set in the BIOS.
COM 1
(RS232/RS422/RS485)
COM 2
(RS232/RS422/RS485)
Antenna Hole
Power Management Switch
HDD LED
Power
Connector
Status LED
Distant Switch
DP++
Volume Control
LAN 1 LAN 2
VGA
Line-out
Mic-in
USB 3.0 USB 2.0
SATA Drive Bay
Power HDD Alarm LED
(green) (orange)
Brightness
Control
2
Power Button
Reset Switch