CPE 100318 매뉴얼 - 페이지 8

{카테고리_이름} CPE 100318에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CPE 100318 10 페이지. 4-bike carrier

Now your Bike Carrier is assembled, follow these instructions below for safe & proper use.

Before every use, verify all components are in good working order. Secure & tighten all

NOTE:

hardware before mounting Bicycles to Carrier. Make sure all Straps & Ties are in good

condition and not worn or frayed.

CAUTION:

– ALWAYS secure your Bicycles to Carrier using

frame Cradles & Straps.

– If any part appears to be worn, frayed, loose,

or broken; DO NOT use Bike Carrier. Please

tighten & replace worn or damaged parts before

use.

– Additional Rope, Bungee Cords, or Cable Locks

may be used for additional security & stability.

Slide the Square Hitch Tube into Receiver Tube of

your Vehicle. Secure Hitch using M12 x 60 Bolt(22),

Ø12 Flat Washer(16) & R-Pin(9) provided.

Lift a bicycle up to Horizontal Bar of Bike Carrier &

place Bike Frame onto Cradle Assembly(4). See image.

MOUNTING

through Ring on Cradle. See image.

over Bicycle Frame. Wrap all the way around until end of

Strap links with tab. See image below.

Call Customer Service if You Have Any Questions

1-877-338-0999

Page 8 of 9

Take Cradle Strap & wrap it over Bike Frame, then

Double Strap over Ring and wrap back around tightly

Repeat actions for additional bicycles.

100318

ENGLISH