Allied Telesis AT-RH509BE 빠른 설치 매뉴얼 - 페이지 4

{카테고리_이름} Allied Telesis AT-RH509BE에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-RH509BE 8 페이지. Micro hubs

BNC

BNC Port - Connect

RJ45 Ports (1-4) - Connect

a thin coax segment

workstations or other devices

to this port

that use twisted pair cabling

Desktop and Wall Installation

To install a single AT-RH500 Series hub either with the Velcro kit or on

the desktop, do the following:

For wall installation, place two Velcro pads on the bottom of the

unit, then place the other pads on a wall. Align the unit's Velcro

pads with the two pads on the wall to attach the unit to the wall.

For desktop installation, attach the four rubber feet to the bottom

of the unit. Then place the hub on a secure desktop.

Caution

Air vents must not be blocked and must have free access to the

room ambient air for cooling

Plug the power supply into a wall socket and connect the DC cable

to the unit. Check the LEDs to ensure that the PWR LED lights.

See Table 1.

Connect the twisted pair cables to the hub's RJ45 ports. Connect

the other ends of the twisted pair cables to the computer's network

adapter card.

Figure 1 Standalone Hub Installation

NOTE: Cable length must not exceed 100 m (328 ft).

page 13.

B N C

5V 1.2A

Power - Use adapter

shipped with hub

5V 1. 2A