AVS 6000 사용자 설명서 - 페이지 7
{카테고리_이름} AVS 6000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVS 6000 7 페이지. Alarm system
페이지 인쇄HOW TO CHANGE PROGRAMMING REGISTER 3
Vehicle setup:
Programmable
feature
Current
sensing
override
Door lock on ignition
2 second exit delay
No door ajar warning
Passive arm from
ignition off only
Perimeter night light
Instant boot release
External pre-warning
output
Past alarm trigger
memory
7
Drivers door open, bonnet open, turn ignition on last
Number
Initial
of
factory
pushes
settings
1
OFF
2
OFF
3
OFF
4
OFF
5
OFF
6
OFF
7
OFF
8
OFF
9
SELECT
to replay
memory
Description
If activated this feature prevents the alarm
from activating via voltage drop.
When on, this feature will lock the doors
when the ignition is turned on and unlock
when the ignition is turned off.
When this feature is on, the normal 20
second exit delay is reduced to 2 seconds
i.e. the alarm is fully armed 2 seconds after
the remote is pushed.
When on, the system will not chirp for 3
seconds if armed with a door open.
When on the system arms automatically 60
sec after exit even though the doors are
not closed. Will not lock.
On disarm the indicators will stay on
constantly for 20 secs.
When on the boot release button (left) will
only required to be pushed once instead of
held down for 3 seconds.
When on, the internal alarm pre-warn is
disabled and a 2 second output from the
boot wire is given.
For use when optional siren is fitted. After
pressing the remote 10 times to enter this
mode, turn the ignition off. The AVS 6000
offers a unique memory that stores the ten
last reasons why the alarm triggered. This
memory cannot be erased.
1 chirp, 1 flash - Voltage drop alarm
2 chirp, 2 flash -.Glass break alarm
3 chirp, 3 flash - Shock sensor alarm
4 chirp, 4 flash – Power fail alarm
5 chirp, 5 flash - Ignition alarm
6 chirp, 6 flash – Aux sensor alarm
7 chirp, 7 flash – Door alarm
8 chirp, 8 flash - Bonnet/boot
If 2 previous alarms were recorded i.e.
door alarm and ignition alarm, the LED will
flash and the siren will beep 7 times for
door alarm, then no noise for 1 second
then chirp 5 times for ignition. The last
memory heard is the most recent
triggered.
Turn the ignition on to exit.