AVS AHDEXT70 사용자 설명서 - 페이지 2

{카테고리_이름} AVS AHDEXT70에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVS AHDEXT70 2 페이지. Hdmi extender over hdbase-t

페이지 인쇄

INTRODUCTION

This HDMI HDBase-T extender uses single CAT-5E/6/7 cable to extend 3D

TV over 70m away from the source. It supports resolutions up to 4k x 2k

full HD and high bit-rate audio formats such as Dolby True-HD and DTS-HD

Master Audio. Support IR control system, IR transport channel can be forward

or backward, IR blaster and receiver pigtails are needed.

By using standard CAT6 cable(recommended), it makes HDMI signal

extension easier to install within a room or through walls. The Extender's

digital transmission uncompressed method insures 100% signal integrity.

PACKAGE CONTENTS

•1 x HDMI Transmitter unit, 1x HDMI Receiver unit

•1 x 12V DC power supply

•1 x User Manual

FEATURES

•HDMI, HDCP 1.2 and DVI Compliant

•Support full 3D pass-through

•Support 4k x 2k high resolution

•Super IR control system, IR transport channel can be forward or backward

per your installation

•70M extension with a Cat5e/6 over HDBase-T technology

•Support POE

•Support CEC bypass

•External and internal EDID settings

PANEL DESCRIPTION

Transmitter Unit

HDMI HDBase-T Extender

1 HDMI INPUT

2 IR RX PORT

3 IR TX PORT

4 CAT5E/6 HDBase-T OUTPUT

5 POWER SUPPLY INPUT

Receiver Unit

HDMI HDBase-T Extender

1 HDMI OUTPUT

2 IR RX PORT

3 IR TX PORT

4 CAT5E/6 HDBase-T INPUT

INSTALLATION

•Connect HDMI input port on transmitter to the signal source equipment

such as DVD player.

•Connect the HDMI output on receiver to the display.

•Connect the HDBase-T output of the transmitter with a CAT5e/6/7 cable

to the HDBase-T input of the receiver.

•Plug the 12VDC power supply into the unit and connect the adaptor to

AC outlet.

To use Bi-directionol IR control function:

1. If you want to control source equipment at the display end, Connect IR

blaster cable (not included in the package)to the IR TX port on Transmitter for

signal transmission. Place the IR blaster in direct line-of-sight of the equipment

to be controlled.Connect IR receiver cable (not included in the package) to the

IR RX port on Receiver for signal reception. Place the IR receiver indirect

line-of-sight of remote.

2. If you want to control the display at the source end, Connect IR blaster

cable (not included in the package) to the IR TX port on Receiver for signal

transmission. Place the IR receiver indirect line-of-sight of remote. Connect IR

receiver cable (not included in the package)to the IR RX port on Transmitter for

signal reception. Place the IR blaster in direct line-of-sight of the equipment

to be controlled.

CONNECTION DIAGRAM

HDMI IN

IR-RX

IR-TX

70 M Extension Over HDBase-T

DC 12V

Cat5e/6

08：08

PLAY