CPG 351COHT4M 사용자 설명서 - 페이지 5

{카테고리_이름} CPG 351COHT4M에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CPG 351COHT4M 14 페이지. Electric countertop convection ovens

User Manual

Installation

•

These units are designed for commercial use and not for household use .

•

Installation must conform to all applicable codes . Improper installation will void the

manufacturer's warranty .

•

Do not obstruct or reduce the air flow rate of the natural ventilation openings on the

oven or the vent located at the rear of the oven .

•

Discontinue use if power cord or electrical wires are frayed or worn .

•

This product conforms to UL-197 standards and is required to be installed under a

ventilation hood in accordance with all applicable codes .

Combustiable Clearance Requirements: 20" Sides, 28" Back

Non-Combustiable Clearance Requirements: 2" Sides, 2" Back

Installation Instructions

The place of installation must be indoors, well ventilated, and the ambient temperature must be at least

40 degrees Fahrenheit . The unit is required to have at least 2" of clearance on the sides and back from

non-combustible surfaces, or at least 20" and 28" of clearance on the sides and back, respectfully, from

combustible surfaces . Ensure that all four legs are installed correctly before the operation of this oven .

The unit is required to be installed on a non-combustible surface with 4" legs, or a combustible floor with

a stand . For full-size models, level unit by adjusting the (4) feet which have an adjustment of 1¾" for

accurate leveling .

This product conforms to UL-197 standards and requires it to be

under an exhaust hood . A vertical distance of not less than 48"

shall be provided between the top of the appliance and filters

or any other combustible material . Exhaust installation must

conform to applicable local codes .

Do not obstruct or reduce the air flow rate of the natural

ventilation openings on the oven or the vent located at the rear

of the oven . To ensure proper ventilation and clearance, the

provided spacer is required to be installed .

The spacer must be installed by screwing (2) self-threading

screws on the back of the unit immediately below the cooling

fan.

NOTE:

For Oven Stacking Instructions, please see page 14.

WARNING:

DO NOT OBSTRUCT THE VENT OR COOLING FAN LOCATED AT THE REAR OF

THE OVEN.