CPG 351FGC200K 서비스 매뉴얼 - 페이지 12

{카테고리_이름} CPG 351FGC200K에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CPG 351FGC200K 18 페이지. Gas powered convection ovens

Service Manual

351FGC100(L/N) | 351FGC200(L/N)K

351FGC100DD(L/N) | 351FGC200DD(L/N)K

ALL GAS CONNECTIONS MUST BE CHECKED FOR LEAKS

Internal Gas Regulator

Turn unit off. Disconnect gas and electrical connections.

Remove hex bolts holding right side on with an 8mm

socket.

Loosen and remove compression nut and union joint from

either side of regulator to remove from unit (Fig. 41).

Remove fittings from both sides of old valve and install

on new valve with an appropriate thread sealant.

Install is reverse of removal. Ensure there are no gas

leaks.

Convert from one gas type to another by changing the burner orifices. Reference 'Gas Burner

Components' on Page 11.

Replace regulator adjustment spring assembly. Reference 'Regulator Pressure Adjustment'

below.

Add new gas decals to Serial plate and internal regulator to reflect change in gas supply type.

Regulator Pressure Adjustment

Manifold pressure can be adjusted. If needed and if

incoming pressure allows.

Remove right side panel hex bolts with an 8mm socket

and remove panel, then remove front lower cover.

Install manometer onto burner manifold behind lower

front panel to check pressure (reference serial plate for

required pressure), monitor if changes are needed

(Fig. 42).

Remove adjustment cover cap on inlet side of

regulator with a flat screw driver (Fig. 43).

Turn adjustment screw under cap as follows:

Counter-Clockwise: Decrease pressure

Clockwise: Increase pressure

ALL GAS CONNECTIONS MUST BE CHECKED FOR LEAKS

Fig. 41

Fig. 42

Fig. 43