DFRobot DFR0489 매뉴얼 - 페이지 2

{카테고리_이름} DFRobot DFR0489에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DFRobot DFR0489 8 페이지. Iot microcontroller

DFRobot DFR0489 매뉴얼

Specification

Operating Voltage: 3.3V
Input Voltage (limits): 3.3~5V (Lithium Battery:3.7V & USB:5V)
Microcontroller: Tensilica L106 (32-bit MCU)
Clock Speed: 80MHz (Maximum: 160MHz)
SRAM:50KB
External Flash Memory: 16MB
DC Current in the Low-Power-Consumption: 46uA
Average Operating Current: 80mA
Maximum Discharging Current: 600mA (LDO-3.3 Output)
Maximum Charging Current: 500mA
Digital Pin x10
Analog Pin x1
SPI interface x1
I2C interface x1
IR interface x1
I2S interface x1
Interface: XH2.54mm Pin (No soldering default)
In Combination of Wi-Fi MAC/ BB/RF/PA/LNA
WiFi: IEEE802.11 b/g/n (2.4 GHz~2.5 GHz), not support 5GHz WiFi
Operating Temperature: -10 ~+55
Dimension: 58 × 29(mm)
Weight: 24g
Board Overview
FireBeetle Board - ESP8266 is not only compatible with ESP8266 PinMap, but also make a special
compatible with Arduino IDE PinMap. Dx (x=0,1,2,3...9)
Fig1: FireBeetle Board-ESP8266 PinOUT
CHG Blink = not connect battery; Light on = Charging; Light off = Charge complete
Note: NC = Empty; VCC = VCC (5V under USB power supply, Around 3.7V under 3.7V lipo
battery.power supply)