DFRobot Beetle Shield 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} DFRobot Beetle Shield에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DFRobot Beetle Shield 4 페이지.

Pinout

The shield is a breakout of the six pins D9, D10, D11 and A0, A1, A2 as well the two power pins +

and – besides the USB socket. The other two power pads on the other side of the Beetle are not

connected with the shield but you still can use them as a power source since they are routed to the

power lines on the Beetle itself.

Beetle shield pinout (click to enlarge)

After soldering the Beetle on the shield you may power it up by connecting a power source from 3V

to 5V with the power pins labeled with + and - on the Beetle shield. With switching the power on by

pressing the button the LED should light up to confirm the power is witched on. At the same time the

LED on the Beetle should light up too. That is the proof that you successful finished the soldering

task.

Now you might program your Beetle controller by connecting a Micro USB cable with the USB

socket of the Beetle.

The pins on the Beetle shield are arranged to connect with standard servo and sensor connectors.

The order is as followed:

Signal VCC GND

Note: If you want to use the additional pins (RX, TX, SCL and SDA) broken out to the Pads on the

backside of the Beetle controller you might need to solder them before you solder the Beetle to the

shield.