ABATEMENT AQUATRAP AT150RS 운영 매뉴얼 - 페이지 6
{카테고리_이름} ABATEMENT AQUATRAP AT150RS에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABATEMENT AQUATRAP AT150RS 6 페이지. Lgr dehumidifier
페이지 인쇄
How to Use the Touch Pad Control Panel
LCD Display:
DEHUMIDIFIER ON.
PURGE ON.
the condensate reservoir.
DEFROST ON.
engaged.
DELAY BAR AND COUNTDOWN.
key.
"TIMER" CLOCK.
CLOCK time, the "TIMER" CLOCK icon displays. The four
digits indicate HOURS and MINUTES remaining in a user
selected timed run cycle.
"TOTAL" CLOCK.
CLOCK time, the "TOTAL" CLOCK icon displays. The
digits indicate how many DAYS the machine has been
used.
"JOB" CLOCK.
time, the "JOB" CLOCK icon displays. The four digits
indicate how many HOURS and MINUTES are logged
against either the CURRENT JOB or the LAST JOB run.
Touch pad control panel includes
one LCD Display, one Indicator
Light (Red/Green) and five touch
pad keys for dehumidifier
operations.
The pump is on and pumping water out of
Frost forming on the coils, defrost cycle
See Start/Stop
When set to show the "TIMER"
When set to show the "TOTAL"
When set to show the "JOB" CLOCK
Touch Pad Keys:
ON/OFF.
Press the ON/OFF key to turn the machine on or off.
When the machine is turned on, it comes on in STANDBY MODE.
The red indicator light and LCD light up. LCD displays the "TIMER"
CLOCK icon. Four time digits flash, which prompts the operator to
either set the "TIMER" by pressing the "TIMER" KEY or to start the
machine directly by pressing the "START/STOP" KEY.
Pressing the ON/OFF key again will turn the machine off. The red
indication light and LCD light go out. Note: In STANDBY MODE, the
machine will automatically turn off if there are no other keys pressed
within 15 minutes.
TIMER.
By using the "TIMER" key, the dehumidification time can be set for
a desired run time period.
The "TIMER" time setting range is from 00:00 to 23:50. It increases
by 10 minutes for every key press.
Press the "TIMER" key without releasing; the time can be adjusted
continually.
START/STOP.
Press
dehumidification.
The dehumidification startup is designed with a compressor delay.
The display reads a numerical countdown from a maximum of 90
seconds to 0. (30 second countdown for the first startup). The DELAY
BAR flashes during this countdown period.
While dehumidification is on, the display shows a "DEHUMIDIFIER
ON" icon.
The dehumidification cycle runs continuously if there is no "TIMER"
set before it starts.
Otherwise, the dehumidification cycle stops as the set "TIMER"
expires.
Pressing the START/STOP key again will stop dehumidification. The
"DEHUMIDIFICATION ON" icon goes off when the dehumidification
cycle is terminated.
the
START/STOP
key
to
start
or
stop