Allied Telesis Patch 1 AT-S63 릴리스 노트 - 페이지 3

{카테고리_이름} Allied Telesis Patch 1 AT-S63에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis Patch 1 AT-S63 14 페이지. At-9400 series basic layer 3 gigabit ethernet switches at-s63 version 3.1.0 patch 1 software release notes

페이지 인쇄

Stacking Features supported in Version 3.1.0 Patch 1

The following features are supported across a stack

Port statistics

Port configurations

Remote Telnet management

Event log

Spanning tree protocol (STP)

Port-based and tagged VLANs

All other features in the AT-S63 Management Software are automatically deactivated when a

stack is powered on.

Stacking Configuration Tips

When stacking more than two switches, use the AT-9424Ts or AT-9424Ts/XP as the master

and backup master switches.

When adding a member switch to a stack, add one switch at a time. Ensure that the stack is

up and stable before adding another member switch.

All ports are disabled during stack discovery. This means that each time you add or remove a

switch from the stack, switching is suspended across all ports until the discovery process is

complete.

Remember that there are different configuration files for the standalone configuration and the

stacking configuration. Be sure to create your desired configuration on both images in case

there is a stack failure.

Table sizes do NOT increase in Stack mode. The table sizes in a stack are:

— 16k MAC Addresses

— 2k ARP Entries

— 4094 VLANs

A stack can have up to four 48-port AT-9448Ts/XP Switches and two 24-port AT-9424Ts / AT-

9424Ts/XP (Master) or eight 24-port AT-9424Ts / AT-9424Ts/XP Switches.

PN 613-000915 Rev A

AT-S63 Version 3.1.0 Patch 1 Software Release Notes

Allied Telesis, Inc.