Allied Telesis Rapier 16F-FX/SC 빠른 설치 매뉴얼 - 페이지 8
{카테고리_이름} Allied Telesis Rapier 16F-FX/SC에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis Rapier 16F-FX/SC 11 페이지. Rapier switch
Allied Telesis Rapier 16F-FX/SC에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (13 페이지), 빠른 설치 매뉴얼 (12 페이지)
페이지 인쇄
8
2.
Set the communication parameters
Set the communication parameters on your terminal or terminal emulation
program to:
•
Baud rate: 9600
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: Hardware
3.
Log in
After the switch has booted, the log in prompt appears. If the log in prompt
doesn't appear, press [Enter] two or three times.
When the switch boots for the first time it automatically creates an account
with manager privileges. The account has the log in name "manager" and
the password is "friend".
At the log in prompt, enter the log in name and password.
Log in: manager
Password: friend
The switch's command prompt appears and you can now configure the
switch using the command line interface.
Change the password as soon as possible. Leaving the manager account with
the default password is a serious security risk. Make sure that you remember
the new password as there is no way to retrieve it if it is lost.
Use the following command to change the account password:
set password
4.
Load help files
To access help, enter:
set help=help-filename
where help-filename is the name of a help file stored in flash.
To see a list of files stored in flash, enter:
show file
Help files have an HLP extension.
To display a list of help topics, enter:
help
To display help on a specific topic, enter:
help topic
Alternatively, type a question mark (?) at the end of a partially completed
command to see a list of valid options.
See the Rapier Switch Software Reference for more information on
configuring the switch.
Rapier Switch
Software Release 2.3.1
C613-04017-01 REV D