Allied Telesis Rapier AR 300 Series 빠른 설치 매뉴얼 - 페이지 7
{카테고리_이름} Allied Telesis Rapier AR 300 Series에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis Rapier AR 300 Series 9 페이지. Ar300 series router
Allied Telesis Rapier AR 300 Series에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (8 페이지), 문제 해결 (5 페이지)
페이지 인쇄
Quick Install Guide
C613-04026-01 REVD
LEDs and What They Mean
System LEDs on its front panel indicate the router's operational status.
Table1: System LEDs
LED
System (red)
Run
Power
Table 2: Port LEDS (Not all routers have all LEDs).
LED
Function
ISDN Active
Lit when the BRI has successfully completed the exchange of INFO 1 and
INFO 2 signals, and INFO 3 and INFO 4 signals are present on the link.
This means that the ISDN interface is correctly connected to a working
NT device.
ISDN B1
Lit when data or voice calls are being transmitted over the B1 channel
of the ISDN interface.
ISDN B2
Lit when data or voice calls are being transmitted over the B2 channel
of the ISDN interface.
LAN Coll (yellow) Lit when a collision is detected on the Ethernet interface.
LAN Data 0
Lit when data is being transmitted over the Ethernet 0 interface.
LAN Data 1
Lit when data is being transmitted over the Ethernet 1 interface.
LAN Link
Lit when the Ethernet interface is connected to a device (e.g., a hub),
which is generating link pulses. This LED is normally lit.
LAN Link 0
Lit when the Ethernet 0 interface is connected to a device (e.g., a hub),
which is generating link pulses. This LED is normally lit.
LAN Rxd
Lit when data is being received on the Ethernet interface.
LAN Txd
Lit when data is being transmitted over the Ethernet interface.
LAN Link 1
Lit when the Ethernet 1 interface is connected to a device (e.g., a hub),
which is generating link pulses. This LED is normally lit.
WAN Active
Lit when a higher layer module (e.g., PPP) has attached to the interface
and DCD or its analog ("I" for X.21) is active. This usually indicates that
the NTU or DSU/CSU is connected to a correctly provisioned data circuit.
WAN ISDN
Lit when data is being transmitted or received over the ISDN interface.
WAN Rxd
Lit when data is being received over the synchronous interface.
WAN Syn
Lit when data is being transmitted or received over the synchronous
interface.
WAN Txd
Lit when data is being transmitted over the synchronous interface.
Function
This LED is not normally lit. It is used to signal various system
conditions (e.g., when the processor executes the reboot
sequence). Generally it signals a possible fault condition, but
it will light briefly during power-up and operator initiated
reboots.
Lit when the internal processor is executing code. If the
processor stops for any reason (a fault condition), then the
LED will not be lit.
Lit when power is supplied and the router is switched on.
7