Allied Telesis Rapier G6f 빠른 설치 매뉴얼 - 페이지 7

{카테고리_이름} Allied Telesis Rapier G6f에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis Rapier G6f 12 페이지. Rapier series

Quick Install Guide

Figure 2: DC Power inlet terminals on a Rapier 24.

FOR CENTRALIZED DC

POWER CONNECTION,

INSTALL ONLY IN A

RESTRICTED AREA

INPUT

38-75VDC

, 2A

DC Power inlet

C613-04017-01 REV H

d) At the switch, connect the positive feed to the + (positive) terminal and

the negative feed to the - (negative) terminal. Tighten the terminals to

between 0.6 and 0.8 Nm (0.041 to 0.055 pound-force per foot)

e) Ensure there are no exposed conductor strands

Secure the supply cable (to the rack framework or similar object) so the

connections are isolated from any force applied to the cable

g) Ensure the circuit breaker is in the Off position

h) Connect the supply-cable wires to the circuit breaker

Energise the circuit breaker

The Fault LED should flash for approximately 10 seconds as the switch

runs internal tests. If the LED continues to flash or remains lit, refer to the

Rapier Switch Hardware Reference for troubleshooting information.

Check that the Power LED on the switch's front panel lights green

If the LED fails to light, refer to the Rapier Switch Hardware Reference for

troubleshooting information.

Connect the Redundant Power Supply (Optional)

AC models of Rapier Switches have a Redundant Power Supply (RPS)

connector on their rear panel (see Figure 1).

The Switch is designed to operate with the AT-RPS8000 RPS, which can be

purchased separately. Contact your authorised Allied Telesyn distributer

or reseller for more information.

10. Connect the data cables

Use straight-through or cross-over Ethernet patch cables to connect the

required device(s) to the switch's ports. Make sure each cable connection is

secure. The switch will now perform basic Layer 2 switching functions. By

default, all switch ports are members of VLAN1.

NSM 0

Swap

Hot Swap

In Use