DG FPGA 설정 - 페이지 13

{카테고리_이름} DG FPGA에 대한 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. DG FPGA 18 페이지.
DG FPGA에 대해서도 마찬가지입니다: 설정 (5 페이지), 설정 (14 페이지), 설정 (20 페이지), 설정 (8 페이지), 설정 (10 페이지)

DG FPGA 설정
dg_toe100gip_fpgasetup_xilinx.doc
8) On Serial console/JTAG Terminal, welcome message is displayed.
i) Input '0' to start TOE100G-IP initialization in client mode (asking PC MAC address by
sending ARP request).
ii) Default parameter in client mode is displayed on the console.
If Ethernet connection has the problem and the linked is down, the error message is
displayed on the console instead of welcome message, as shown in Figure 2-12.
iii) User enters 'x' to skip parameter setting for using default parameters to begin system
initialization, as shown in Figure 2-13. If user enters other keys, the menu for changing
parameter is displayed, similar to "Reset TCPIP parameters" menu. The example
when running the main menu is described in "dg_toe100gip_cpu_instruction"
document.
Note: Transfer performance in the demo is limited by Test PC performance in Test platform.
The best performance can be achieved when the test is run by using FPGA-to-FPGA
connection.
28-Apr-21
Figure 2-11 Message after system boot-up
Figure 2-12 Error message when cable is linked down
Figure 2-13 Initialization complete
Page 13