Allied Telesis Rapier Series 릴리스 노트 - 페이지 7

{카테고리_이름} Allied Telesis Rapier Series에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis Rapier Series 8 페이지. How to set up pppoe between a linux client and access concentrator
Allied Telesis Rapier Series에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (8 페이지), 문제 해결 (5 페이지), 구성 방법 (9 페이지), 방법 (8 페이지)

페이지 인쇄

Patch 86253-03 For Rapier Series Switches

Syntax

Description

Examples

New Commands

This enhancement request introduces two new commands from enabling/

disabling all-group entries on switch ports.

ENABLE IP IGMP ALLGROUP

ENABLE IP IGMP ALLGROUP=[{port-list|ALL}]

where:

■

port-list is a port number, a range of port numbers (specified as n-m), or a

comma separated list of port numbers and/or ranges. Port numbers start

at 1 ad end at m, where m is the highest numbered Ethernet switch port,

including uplink ports.

This command enables the specified port(s) to behave as a multicast all-group

ports.

The ALLGROUP parameter specifies the list of ports able to behave as all-

group entry ports. If ALL is specified, all ports are able to behave as all-group

entry ports. The default is ALL.

To enable ports 1, 5 and 7 to behave as all-group entry ports, use the command:

ENABLE IP IGMP ALLGROUP=1,5,7

DISABLE IP IGMP ALLGROUP

SHOW IP IGMP

DISABLE IP IGMP ALLGROUP

DISABLE IP IGMP ALLGROUP=[{port-list|ALL}]

where:

■

port-list is a port number, a range of port numbers (specified as n-m), or a

comma separated list of port numbers and/or ranges. Port numbers start

at 1 and end at m, where m is the highest numbered Ethernet switch port,

including uplink ports.

This command disables the specified port(s) from acting as a multicast all-

group entry ports. Ports that are disabled have a "#" symbol next to the port

number in the output of the SHOW IP IGMP command.

To prevent ports 1, 5 and 7 from behaving as all-group entry ports, use the

command:

DISABLE IP IGMP ALLGROUP=1,5,7

ENABLE IP IGMP ALLGROUP

SHOW IP IGMP

DISABLE IP IGMP ALLGROUP