DG USB3D-IP 매뉴얼 - 페이지 3

{카테고리_이름} DG USB3D-IP에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DG USB3D-IP 16 페이지. Usb3.0 device function ip-core

dg_usb3.0_dev_ip_demo_instruction_en.doc

2 2 2 2 . . . . Evaluation procedure

Evaluation procedure

2 2 2 2 - - - - 1 1 1 1 Altera E

Altera Evaluation Procedure

Altera E

valuation Procedure

For Altera USB3.0 Device-IP evaluation, follow evaluation procedure below.

Check that both Altera board (CycloneIV GX/CycloneVE/ArriaV GX starter board) and adapter

•

board are powered off.

Connect USB Cable to USB connector on Altera board (J4 for CycloneIV GX board/J10 for

•

CycloneVE board/J14 for ArriaV GX starter board) for JTAG programming and JTAG UART

operation.

Set HSMC interface voltage of CycloneIV GX board to 2.5V. (Short J3 header. Refer to CycloneIV GX

•

board manual for more detail.)

Connect adapter board (AB08-USB3HSMC) to HSMC connector.

•

Confirm that JP1 on the adapter board is not jumped (OFF).

•

Connect USB3.0 AtoA cable with USB connector on the adapter board.

•

Connect opposite side of USB3.0 AtoA cable to the USB3.0 connector of the Host PC.

•

15 May 2015

Figure 3 3 3 3 : Adapter board connection to CycloneIV GX

Figure

: Adapter board connection to CycloneIV GX board

Figure

: Adapter board connection to CycloneIV GX

board

Page 3