CPI 1122 조립 설명서 - 페이지 15

{카테고리_이름} CPI 1122에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CPI 1122 15 페이지.

CPI Satcom & Antenna Technologies

SECTION IV

4.0

After installation, the antenna requires only periodic inspection.

anticipated that maintenance, if required, will be minimal and easily handled

by a local or in-house maintenance staff.

4.1

CPI's reflector does not require any maintenance. The composite construction of

the reflector is virtually impervious to any damages that could be caused by

weather or atmospheric conditions. It is only necessary to inspect for any physical

damage done by vandalism or very severe weather conditions.

Should any damage be detected to a portion of the reflector, contact the Customer

Service Department at CPI for recommendations involving reflector repair.

4.2

MOUNT AND REFLECTOR SUPPORT STRUCTURE

The mount and reflector support structure supplied with this antenna is of steel

construction and have a galvanized finish.

If there are any signs of structural failure, the mount members that are damaged

should be repaired or replaced.

4.3

FEED AND FEED SUPPORT

The feed support rods should be inspected to insure that all hardware is secure.

The feed/radio mounting bolts should be tight.

The feed horn window should be inspected to insure that it is intact so that no

moisture can collect inside the feed horn.

MAINTENANCE

1.2M Ku-BAND SERIES 1122

4096-1000

It is