Avsl 178.155UK 사용자 설명서 - 페이지 3

{카테고리_이름} Avsl 178.155UK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avsl 178.155UK 9 페이지. Active speaker cabinets with dsp

Rear panel layout

Setting up

Position your CLARA active speaker cabinet(s) on a stable surface capable of supporting the load and

vibrations from the cabinet or ideally on a strong 35mmØ pole mount or speaker stand with an adequate safe

working load to support the cabinet. Also, each CLARA cabinet has M8 flying points for suspending from a

ceiling or truss if required. It is recommended to use 3 or more fixing points for suspension.

Aim the cabinet towards the audience or listeners and not in direct line of sight with any microphones that are

connected to the sound system to avoid feedback (howling or squealing caused by the mic "hearing" itself)

Each CLARA active speaker has an inbuilt Bluetooth receiver, which can be paired with a smart phone by

holding the Bluetooth on/off & pairing button (3) for 3 seconds. The blue status LED will flash to indicate

pairing mode. Search for "CLARA-12A", or "CLARA-15A" in the Bluetooth menu of the smart phone and select

to pair. Once paired, the LED will be lit constantly and the audio output from the smart phone will be

streamed wirelessly to the CLARA speaker. This input is governed by the LINE A input & Bluetooth level

control (9). Pressing the Bluetooth on/off pairing button briefly will switch the Bluetooth receiver on or off. If a

previously paired device is within range, the Bluetooth receiver will auto connect.

If a mixing console is being used to control input sources, connect the output of the mixer to the CLARA

cabinet LINE input (4) or MIC/LINE (6) with "LINE" selected on the MIC/LINE switch (10) using XLR or 6.3mm

jack connectors. If the system is in stereo, then usually one CLARA cabinet will serve the right-side output and

another for the left-side output. Normally, the volume of the CLARA cabinet LINE input is turned up high and

the output will be controlled at the mixer.

A microphone may also be connected directly to input A if the MIC/LINE switch (10) is in the "MIC" position.

If a playback device (e.g. mp3 or CD player) is to be connected directly to the CLARA cabinet, this is usually

connected to the LINE A input using a stereo to mono lead.

If the inputs to the CLARA speaker cabinet are to be linked onto a further active cabinet or amplifier, the mix

of all MIC/LINE/Bluetooth inputs can be fed from the MIX OUT line output XLR to further equipment (5)

When all necessary connections are made, finally connect the supplied IEC power cable (or equivalent) from

the mains power supply to the IEC power inlet on the CUBA speaker cabinet, ensuring that the supply voltage

is as indicated on the CUBA speaker unit (14)

DSP display

DSP USB port

Bluetooth on/off/pairing button

INPUT A line input XLR/Jack socket

MIX OUT line output XLR

INPUT B mic/line input XLR/Jack socket

IEC power inlet and fuse holder

DSP control rotary selector

LINE A input & Bluetooth level control

10.

Input B MIC or LINE level switch

11.

MIC/LINE B input level control

12.

POWER on/off switch

CLARA active speaker cabinets User Manual