Abatement Technologies PRED1200 사용 설명서 - 페이지 6

{카테고리_이름} Abatement Technologies PRED1200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Abatement Technologies PRED1200 17 페이지. Portable air scrubber

Abatement Technologies PRED1200 사용 설명서

REQUIREMENTS FOR SAFE OPERATION

1. Never allow unauthorized individuals or children to operate the unit at any time.
2. Abatement Technologies urges anyone operating the PRED1200 to wear the proper personal protective
equipment and follow safe work practices in accordance with federal, state, provincial and employer
regulations.
3. Check the condition of power cord(s) before using them. Damaged cords can cause fatal electric shock and/
or motorized impeller failure.
4. Power cord(s) should never be exposed to water, heat, sharp, or abrasive objects; in addition, they should
never be kinked or crushed. Avoid tightly wrapping the cords to prevent kinking of the internal wires. Always
replace damaged power cords immediately.
5. Never pull the unit by the power cord.
6. Avoid running over power cords with utility equipment and vehicles.
Important Safety Instructions
a. Do not operate any unit with a damaged cord or plug. Discard unit or return it to an authorized
service facility for examination and/or repair.
b. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area
and where it will not be tripped over.
Caution: As with any piece of electrical equipment, always make sure that the unit is turned "OFF" prior
to connecting the power cord to an electrical outlet or disconnecting it from an electrical outlet. Failure
to do so will cause "arcing", and could result in personal injury, fire hazards and/or damage to the unit.
Do not disconnect the power cord from supply receptacle while the unit is operating.
Warning: To reduce risk of electrical shock, do not expose this unit to water or rain. Do not touch the
electrical outlet or power cord(s) with wet hands or while standing on a wet or damp surface.
Warning: Risk of electrical shock! Can cause injury or death! Turn unit "OFF" and disconnect power
cord from supply receptacle before replacing the HEPA filter and before cleaning or servicing the unit.
Warning: The PRED1200 is equipped with an automatic restart motorized impeller that will restart without
warning after a temporary power interruption or recovery from a thermal overload (over-heating)
condition. Keep clear of the motorized impeller at all times to reduce the risk of injury.
Warning: To reduce risk of fire or electrical shock, do not use the PRED1200 with any solid state speed
control device. Do not use in a cooking area.
Caution: The PRED1200 is designed for indoor use only.
CAUTION: For General Ventilating Use Only. Do Not Use To Exhaust Hazardous Or Explosive
Materials And Vapors.
Warning: Abatement Technologies air filtration systems are not intrinsically safe for use in hazardous
environments. Always consult a certified industrial hygienist before using them. Do NOT use this
equipment in any atmosphere that is or may be immediately dangerous to life or health (IDLH),
combustible, flammable, explosive, oxygen deficient, and/or contains odors, vapors, gases or particulates
that exceed permissible exposure levels. Such atmospheres may require the use of intrinsically safe
equipment, specific engineering controls, and personal protective equipment in accordance with
Occupational Safety and Health Administration (OSHA), Environmental Protection Agency (EPA), Canadian
Standards Association (CSA), and other federal, state, provincial and local regulations.
Warning: This equipment is not classified as "intrinsically safe" and should not be used in the
following hazardous locations as defined by the Underwriters Laboratories: Class I Division 1, Class I
Division 2, Class I Zone 0, Class I Zone 1, Class I Zone 2, Class II Division 1, Class II Division 2, Class
III Division 1, Class III Division 2. Refer to the UL web site: http://www.ul.com/hazloc/define.htm.
Warning: Do not use this unit near sparks, open flames or other possible sources of ignition.
5