CPI TALOS T700 설치 매뉴얼

{카테고리_이름} CPI TALOS T700에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CPI TALOS T700 2 페이지. Bill validator

페이지 인쇄

bezel led error flash codes

When the unit is ready and enabled, the bezel LEDs will flash continu-

ously. If the bezel LEDs are off, the unit has an error. To determine the

error, partially insert and hold a bill in the bill path until the bezel lights

flash. Count the flashes and refer to the chart below.

Flashes

Problem

Solution

None

No power

Restore power to validator or machine

1 or 4

Bill path

Check for jams. Remove bill

blocked

magazine and lower housing

assembly and inspect

Another

Ensure the unit has been enabled,

vending

then check:

component

• Vending Machine Controller

• Coin manager and coin levels

• Inventory levels

• The door is locked properly

Lower

Check that the lower housing

housing

assembly is seated. Ensure bill path

assembly

is clean; see Cleaning section

Bill magazine

Reattach bill magazine

removed

Continuous

Stacker full

Empty the bill magazine

fast

Continuous

Unit is

Replace the unit

slow

defective

Talos_Install_Guide_5.24.19.indd 1

Troubleshooting

These are some common, easy-to-solve issues that may pop up during

Installation:

If this happens

Try

Check Harnesses: Cables may be

loose, not properly connected or pins

may be bent

The unit will not power

Check Source Voltage: Ensure that

power is being supplied to the bill

validator.

Ensure the unit has been enabled, then

check:

The unit has power, but

• Vending Machine Controller

will not accept a bill

• Coin manager and coin levels

• Inventory levels

• The door is locked properly

cleaning

The Talos bill validator will not need to be cleaned as often as magnetic

sensing bill acceptors. If cleaning is required, use a soft cloth moistened

with a mild, non-abrasive detergent.

Compliance

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (a)

This device may not cause harmful interference, and (b) this device must accept any interference received,

including interference that may cause undesired operation.

Except as permitted under the relevant local legislation, no part of this publication may be copied, trans-

mitted, transcribed, or distributed in any form or by any means, or stored in a database or retrieval system,

or translated in any language (natural or computer), without the prior written permission of CPI. MEI UK

International, MEI Cashflow® and the MEI device are registered trademarks.

CPI reserves the right to change the product or the product specifications at any time. While every effort

has been made to ensure that the information in this publication is accurate, CPI disclaims any liability for

any direct or indirect losses (howsoever caused) arising out of use or reliance on this information. This

document does not necessarily imply product availability. Note: Your product may differ slightly from some

of the illustrations in this document.

CPI Corporate Headquarters

3222 Phoenixville Pike

Suite 200

Malvern, PA 19355

CranePI.com

talos t700 install guide

The Talos bill validator is designed to fit into the standard bill acceptor

opening in most vending machines and can be mounted on existing

studs or a mounting bracket.

Features

– Four way bill acceptance

– Coupon and bill configuration

– Supports High Visibility and Credit Card Reader Bezels

Interface

The Talos bill validator operates via MDB interface. The 24VDC MDB

harness is included.

Operating Voltage

See the label on the side of the device.

5/24/2019 9:54:44 AM