Abatement Technologies AQUATRAP AT150R 운영 매뉴얼 - 페이지 8

{카테고리_이름} Abatement Technologies AQUATRAP AT150R에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abatement Technologies AQUATRAP AT150R 12 페이지. Lgr dehumidifier

Abatement Technologies AQUATRAP AT150R 운영 매뉴얼
Touch Pad Keys (Cont.):
PURGE.
pump reservoir. During normal operation, the pump purges
automatically whenever the reservoir is full. The display will
show the PURGE ON icon.
TO
TRANSPORTATION:
DISPLAY.
CLOCK, "TOTAL" CLOCK or "JOB" CLOCK while the
machine has been turned on. Pressing the DISPLAY key
will advance which clock time is displayed. Only ONE
choice of clock time can be displayed at a time.
Press the PURGE key to empty water from the
PURGE
THE
Stop dehumidification using the START/STOP key,
and let the unit sit for about 10 minutes. This allows
water to drip from the coils.
Press PURGE to remove residual water.
Press the DISPLAY key to display "TIMER"
In STANDBY MODE, the default display is "TIMER"
CLOCK time. Press the DISPLAY key once to display
the "TOTAL" CLOCK time. Press it again to display
"JOB" CLOCK time, which shows the LAST JOB run
time.
When the dehumidifier is operating in a pre-set
"TIMER" run cycle, the default CLOCK display is
"TIMER" CLOCK time, which shows the remaining run
time of the CURRENT JOB. Press the DISPLAY key
once to display the "TOTAL" CLOCK time. Press it
again to display "JOB" CLOCK time, which counts the
CURRENT JOB run time.
When the dehumidification is running continuously
without a "TIMER" setting, the default CLOCK display
is "JOB" CLOCK, which shows the CURRENT JOB
running time. Press the DISPLAY key once to display
"TIMER" CLOCK time, which reads "00:00". Press it
again to display the "TOTAL" CLOCK time.
If the DISPLAY key has not been pressed within 15
seconds, the CLOCK time will revert back to its
default display.
When error messages appear, "TIMER", "TOTAL" and
"JOB" CLOCK displays disappear. Press DISPLAY
key once to get the clock displays back once errors
are cleared.
PUMP
MANUALLY
BEFORE