CPO Science Physics Stand 조립 지침

{카테고리_이름} CPO Science Physics Stand에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CPO Science Physics Stand 2 페이지.

Physics Stand

Assembly Instructions

The Physics Stand Base & Bolt

1. Put bolt through base from the bottom side of the Physics

Stand base.

The bolt should be pushed through the triangle-shaped opening

so that the threaded end protrudes through the top.

The bolt will seat as shown below.

base

(bottom)

2. Place the washer over the protruding threads on the top side

of the base.

3. Thread the pole onto the protruding end of the bolt.

Continue until snug.

base

(bottom)

base

(top)

Attaching the Pole

To secure tightly, place wrench (metal rod) through

holes in pole (as shown below) and turn clockwise

while holding base.

Place the Physics Stand on a table.

base

(top)

pole

washer

Marble Storage

There is a pocket in the Physics Stand base

for storing marbles or

other small parts during

an investigation.

Assembly instructions continue on page 2.

Page 1

bolt

wrench

base

692-8501 03.11