CPR AeroForce 2 매뉴얼

{카테고리_이름} CPR AeroForce 2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CPR AeroForce 2 4 페이지.

CPR Aquatic, INC•P.O. Box 1111•3749 West End Road, Arcata, CA 95521

As many hobbyists venture into the world of reef keeping, a common goal among most is to keep the filtration

system as simple as possible. One of the most important components to filtration is the removal of compounds

which could eventually break down into ammonia and nitrite. The AeroForce 2

highly efficient protein skimmer for a reef system. The AeroForce 2

maintenance easier and for sturdier construction. Requiring no supplemental plumbing, the AeroForce 2

hangs on the back of the tank and can be installed in a few short minutes.

To place your AeroForce 2

1) Carefully remove all packaging and inspect the unit for damaged or missing parts. You should have:

(1) Outer acrylic body

(1) Inner protein skimmer body

(1) Pico400 (feed pump)

(1) Ario4 (skimmer pump) glued to acrylic base plate

(1) Collection cup assembly with "O" ring and lid

(1) O-ring for base plate support (packaged with Ario 4 pump cord)

(1) Support pin

If any items are damaged or missing, please contact your dealer immediately.

2) Rinse inside of the AeroForce 2

3) Remove inner body from outer body. Feed the power cord from the Ario4 through the center of the o-ring.

Connect the airline to the pump. Insert the base plate with the attached Ario4 pump (#8 pg.4 diagram) to the

inside skimmer body by using the o-ring to hold into position. Insert the base plate from the bottom of the inner

skimmer body (3) and stretch the o-ring to hold onto the support bars (10) on the sides of the opening. Pull

the slack out of the airline and make sure it is secured through the airline access hole and into the black airline

clip on the side of the unit.

4) Slide the inner skimmer body (3) into the outer body (4). The inlet pipe parts 1 and 2 should line up once the

two bodies are together (see page 4).

5) Attach the Pico4 (9) to the inlet part 2.

6) Hang the AeroForce 2

AeroForce 2

so that it is parallel to the back of the tank. Insert the support pin into the desired position

first, and then adjust the screws accordingly.

7) Clean the collection cup (1) including the throat of the funnel in hot water. This will cause the skimmer to begin

collecting waste faster. Do not use any detergents on the collection cup. Insert cup inside protein skimmer

section with O-ring placed around the outside. The o-ring acts as a support for the cup to rest on top of the

AeroForce 2

body. This is not intended to form a seal inside the body.

CPR Technical Support (707) 826-9636 • FAX (707) 826-9623

AeroForce 2

into operation:

with warm water. (optional)

on your tank. Use the adjustment screws (11) and support pin (12) to position the

www.cprusa.com • [email protected]

is designed to provide a simple yet

employs a new dual-body chamber to make

simply