DG Flugzeugbau DG-1001 구축 지침 - 페이지 3

{카테고리_이름} DG Flugzeugbau DG-1001에 대한 구축 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DG Flugzeugbau DG-1001 6 페이지. All fiberglass 1/8 scale sailplane

The glider is ready to fly right after the installation of the RC set.

1. How to install the rudder servos

Glue the servo holder plate into the fuselage. The best position is in the rear cockpit. Insert the

0.8 mm steel wire with inner tubes into the outer bowdens. Cut the bowden tube to the proper

length, insert it into the fuselage. Check if all bends are smooth and glue the bowden in several

points. Push in the steel wire of 0.8mm diameter, cut to the proper length. Remove the wire

again, solder the brass metal ending and screw in the link, which will be later connected to the

rudder horn.

2. Rudder installation

The rudder is mounted on hinges. Make slots for hinges in both the stabilizer and the rudder - the

rudder must fit to the stabilizer. Glue the hinges into the stabilizer and then glue the rudder to the

hinges - mounting the rudder to the stabilizer this way. Find the position of the rudder control

horn so that the straight line connecting the holes in the horn and the axis of rotation of the

control surface is perpendicular to the surface of the stabilizer and the horn itself is in the same

level as the control wire coming from the fuselage. Drill two holes and fix the horn. Insert the

previously prepared wire into the bowden and connect it to the horn.

3. How to install the elevator servo

Drill the holes in the elevator with a diameter of 3mm for the screws. You must open the hole

for the servo in the vertical fin. It is advisable to use a small milling cutter.

Glue up the servo in the fin. Glue up the control lever on the elevator flap and join it using a

draw rod with the servo. Attach the cover.

open

4. Fitting the cockpit