Allied Telesis XEM-12T-N 설치 매뉴얼 - 페이지 10

{카테고리_이름} Allied Telesis XEM-12T-N에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis XEM-12T-N 11 페이지. Expansion module

x900-24X Series Switch Expansion Modules

Installation Procedure

Before you begin:

■

Unpack the expansion module.

In an anti-static environment, remove the expansion module from its packing

material. Be sure to observe ESD precautions.

Caution Failure to observe proper anti-static procedures may damage the

unit. If you are unsure about correct procedures, contact your authorised

Allied Telesis distributor or reseller.

■

Verify the package contents if you have not already done so.

See

"Package Contents" on page

contact your authorised distributor or reseller.

■

Read the safety information for the switch.

Safety information is available in the Installation and Safety Guide that is on

the CD-ROM for the x900-24X Series switch. Or you can download this

document from www.alliedtelesis.com/support/software.

■

Gather necessary tools.

You may need a Phillips #2 screwdriver to adjust the retaining screws on a

blank faceplate.

Procedure

If you want to swap expansion modules, first save your configuration file as

necessary (with create config and set config commands).

If connected, disconnect the switch from its redundant power supply.

Disconnect the switch from its AC or DC power supply.

Loosen the thumbscrews to the faceplate or existing expansion module,

and remove it.

Keep the faceplate for future use. If you remove the expansion module,

cover the bay with the faceplate to prevent dust and debris from entering it

and to maintain proper airflow

Carefully slide the module into the empty bay until you feel it engage the

rear plug.

4. If any items are damaged or missing,