CPR v.105 사용자 설명서 - 페이지 4
{카테고리_이름} CPR v.105에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CPR v.105 15 페이지. The all-in-one call blocker
페이지 인쇄S E T T I N G U P
C P R C A L L B L O C K E R
Step 1
Step 1
Remove the line cable from your telephone and plug into the LINE 1 port of the Call
Remove the line cable from your telephone and plug into the LINE 1 port of the Call
Blocker.
Blocker.
Step 2
Step 2
Use the small Black cable provided to connect the TEL 1 port to your telephone
Use the small Black cable provided to connect the TEL 1 port to your telephone
Step 3
Step 3
Insure all cables are connected securely
Insure all cables are connected securely
The Call Blocker is setup correctly when there is a red light displayed on the top of the
The Call Blocker is setup correctly when there is a red light displayed on the top of the
unit, this is shown when the phone is off the receiver or when on a call. If you are using
unit, this is shown when the phone is off the receiver or when on a call. If you are using
a cordless phone then press the Call Button for a dial tone.
a cordless phone then press the Call Button for a dial tone.
If you have no dial tone or no red light you will need to disconnect the cables then
If you have no dial tone or no red light you will need to disconnect the cables then
reconnect using the LINE 2 and TEL 2 ports.
reconnect using the LINE 2 and TEL 2 ports.
Disconnect line cable from
your telephone and plug into
02.
the LINE 1 port of the
Call Blocker
2