Allied Telesis AR450S 빠른 설치 매뉴얼 - 페이지 4

{카테고리_이름} Allied Telesis AR450S에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AR450S 12 페이지. Ar400 series
Allied Telesis AR450S에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (12 페이지)

페이지 인쇄

Selecting a Site

The router should be installed on a level surface such as a desktop or bench.

When installing the router, choose a site that:

■

Allows adequate airflow around the router and its vents.

■

Is free of dust and moisture.

■

Will maintain an ambient temperature range of 0 to 40º C (32 to 104º F) and

a humidity range of 5 to 95% non-condensing.

■

Has a reliable and earthed (grounded) power supply circuit, preferably

dedicated and filtered.

■

Does not expose cabling to sources of electrical noise, such as radios,

transmitters, broadband amplifiers, power lines, electric motors, and

fluorescent fixtures.

■

Allows easy access to the router's power and cable connections.

Installing the Router

This equipment must be earthed.

Follow these steps to install the router:

Read the safety information.

For safety information, see the Safety and Statutory Information booklet. A

copy of this booklet is supplied with each router, and can also be found on

the Documentation and Tools CD-ROM or at

www.alliedtelesyn.co.nz/support/ar400/

Unpack the router.

Verify the package contents. If any items are damaged or missing, contact

your sales representative.

Place the router in its operating location.

See the previous Selecting a Site section for guidelines on choosing a

suitable location.

Check the supply voltage and the router's rated voltage.

AR450S routers are fitted with a universal mains power supply that will

function over the range 100-240 VAC and 50–60Hz.

The specific power supply requirements for a particular model are clearly

displayed on the rear or underside of the router. If the supply is outside the

accepted range for the router, the router may not operate and damage to the

router may result.

AR450S Router

C613-04045-01 REV A