Allied Telesis AR740 RPS 빠른 설치 매뉴얼 - 페이지 7

{카테고리_이름} Allied Telesis AR740 RPS에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AR740 RPS 13 페이지. Ar700 series router
Allied Telesis AR740 RPS에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (6 페이지)

페이지 인쇄

Quick Install Guide

Figure 2: DC Power inlet terminals on an AR740.

FOR CENTRALIZED DC

POWER CONNECTION,

INSTALL ONLY IN A

RESTRICTED AREA

38-75VDC

Software Release 2.6.1

C613-04027-01 REV E

DC Power

, 2A

Power inlet

The System LED should flash for approximately 10 seconds as the router

runs internal tests. If the LED continues to flash or remains lit, refer to the

AR Router Hardware Reference for troubleshooting information.

DC models do not have RPS connectors.

10. Connect the data cables

Make sure each cable connection is secure.

11. Initiate router start-up

Using the terminal cable supplied, connect a VT100-compatible terminal,

or the COM port of a PC running a terminal emulation program such as

Windows Terminal, to the console port (port 0) on the router's rear panel.

Set the communication parameters on your terminal or terminal emulation

program to:

•

Baud rate: 9600

•

Data bits: 8

•

Parity: None

•

Stop bits: 1

•

Flow control: Hardware

See the AR Router Hardware Reference for more information on configuring

emulation software.

12. Log in and set password

The log-in prompt appears on the terminal or PC. If the log-in prompt

doesn't appear, press [Enter] two or three times.

When the router boots for the first time, it automatically creates an account

with manager privileges. The account has the log-in name "manager" and

the password is "friend".

At the log-in prompt, enter the log-in name and password.

Password: friend

The router's command prompt appears and you can now configure the

router using the command line interface.

SYN