CPS TEMP-SEEKER TM360C 소유자 매뉴얼 - 페이지 6
{카테고리_이름} CPS TEMP-SEEKER TM360C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CPS TEMP-SEEKER TM360C 20 페이지. Precision thermo-psychrometer multi-channel air conditioning humidity and temperature drop tester
OPERATION
Turning the instrument ON and Off: Press the
key to turn the instrument on; the LCD
will initially display all characters, the software version used (CPS 110 or similar) and
whether the automatic power off feature is enabled or not (APO ON or APO OFF). The
instrument will then default to displaying the measurement read in channel A. To turn the
unit off, press and hold the power key for approximately 3 to 5 seconds until the letters
BYE appear on the LCD, then release the key and the unit will turn off.
Memory Function: The instrument will record and store the high and low values of all
channels as long as the instrument remains ON. To view, press the MAX,CUR,MIN key
until the desired reading is displayed. MX or MN characters will appear on the LCD to
indicate which value is being displayed. At any time, the displayed units can be changed
from Imperial to Metric by pushing the I/M key.
APO ON/OFF: This feature, when enabled, turns the TM360A off after 10 minutes if no
key has been pressed. To toggle the feature ON or OFF, press and hold the CLR key and
turn the instrument on. Hold the CLR key down until the APO ON or OFF message ap-
pears on the display, then release the CLR key. The selection is stored in the memory of
the TM360A until it is changed by the user.
Temperature Differential: The instrument can display the temperature difference
between any two of the four available temperature channels. This is done by pressing the
DIFF key followed by the keys representing the two channels for which the temperature
difference is desired. For instance, the sequence DIFF
A
C displays the algebraic
difference between the temperature values at channel A and C.
Display Units: At any time the displayed units can be changed from Imperial to Metric
by pushing the I/M key.
Scan Key: Press this key to display the measurements from temperature channels A
through D in approximately 3 second intervals. The measurements displayed can either
be the current (CUR), maximum (MAX) or minimum (MIN) readings of each channel
depending on the selection of the MAX,CUR,MIN key. The (CLR) key can be used to clear
the MIN and MAX values and replace them with the current reading.
Backlight: An efficient EL panel illuminates the LCD when the
key is activated and
remains on for 15 seconds.
Low Battery Indicator: The symbol BAT will appear on the LCD when 10% battery life
remains.
OP/SP: The OP symbol appearing on the display means the selected temperature chan-
nel either has no probe connected or the probe is open. Verify that a probe is firmly
connected to the channel's RCA connector. If a probe is connected, try rotating the
connector; if the symbol persists on the display, the probe is defective. The SP symbol
appearing on the display means the probe is shorted and must be replaced.
6