CPS Pro-Set LDA1000H 운영 매뉴얼 - 페이지 8

{카테고리_이름} CPS Pro-Set LDA1000H에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CPS Pro-Set LDA1000H 12 페이지. Refrigerant leak detector
CPS Pro-Set LDA1000H에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지), 운영 매뉴얼 (14 페이지)

페이지 인쇄

1. Product View

OPERATION

With a sensor life of more than 500 hours and a battery life of

over 50 hours, very little maintenance is required to keep the

LDA1000H in top operating conditions. Below are the proper

procedures to follow when changing batteries and sensors.

Low battery indication:

When the batteries reach approximately 10% of capacity, the

green LED next to the symbol (

batteries, slide the bottom cover of the instrument backwards to

reveal the battery compartment. Replace the batteries with a new

set of (3) size "C" alkaline batteries.

Changing the E_MOS™ sensor:

See page 9 for the sensor replacement diagram.

• Remove the E_MOS™ sensor housing tip by turning it

counterclockwise.

• With a pair of tweezers or a needle nose pair of pliers gently

pull the E_MOS™ sensor away from its socket.

• Inspect the inside of the sensor housing and verify that there

is an O-ring over the socket and that no dirt or debris is

present. If there is dirt or debris, gently pull the O-ring out, use

a dry cotton swab to loosen the dirt and blow with compressed

air. Clean the O-ring and replace.

Do not cover the O-ring with Vaseline or any other

lubricant.

• Install the replacement E-MOS sensor. Orient the tab on the

edge of the sensor so it coincides with the slot on the side of

the housing and gently push the

Do not use silicone based hand cleaners or lotions prior

to installing a new sensor as this will irreversibly affect

the operation of the sensor.

• Remove and discard the filter inside the sensor housing's tip.

Replace with a new filter disk, making sure no dirt, water, oil

or any other substance comes in contact with filter. It is

recommended to first clean the sensor housing's tip with

alcohol or some other solvent which does not contain oil or

silicone. Use a cotton swab to first loosen any debris from the

tip's opening. Finish by blowing with dry, oil-free, compressed

air. Re-attach the tip to the sensor housing, screwing it finger

tight.

Do not use acetone or silicone based solvents, lotions or

un-cured adhesives while handling the E_MOS™ sensor.

Maintenance

) will turn off. To replace the