CPS Pro-Set VP10DJ 운영 매뉴얼 - 페이지 8

{카테고리_이름} CPS Pro-Set VP10DJ에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CPS Pro-Set VP10DJ 10 페이지. Dual stage vacuum pump

OPERATION

1. If the vacuum pump is equipped with a dual voltage motor, make sure the voltage

selector switch is set for the desired voltage operation.

2. The vacuum pump is shipped without oil in the reservoir. Remove the exhaust/oil fill

cap and add oil until it is seen in the middle of the oil sight glass. Re-secure cap.

3. Remove the 1/4" inlet service port cap, turn on the vacuum pump. After 15 seconds,

replace 1/4 cap back on inlet port.

4. Re-check vacuum pump oil level. Add or remove oil if necessary.

To achieve good final vacuum levels, the oil level should be visually seen through sight

glass.

CAUTION: DO NOT RUN THIS EQUIPMENT WITH LOW OR NO OIL. RUNNING THIS

EQUIPMENT WITH NO LUBRICATION WILL CAUSE PREMATURE FAILURE.

WARNING: Do not operate on systems under pressure.

1. Check the correct power supply outlet to

be used.

2. The VP series is equipped with a dual

voltage motor. Make sure the voltage

selector switch is set for the desired

voltage operation.

Caution: The motor will overheat and

trip the thermal protector if the voltage

selector and the power supply voltage do

not match.

3. Connect the correct power cord from

vacuum pump to power supply outlet.

4. Check oil level in vacuum pump.

Initial Preparation

VACUUM PUMP IS NOW READY FOR USE.

Damage to the pump may occur.

Figure - 1