Allied Telesis AT-9800 Series 방법 - 페이지 2

{카테고리_이름} Allied Telesis AT-9800 Series에 대한 방법을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-9800 Series 8 페이지. How to set up pppoe between a linux client and access concentrator
Allied Telesis AT-9800 Series에 대해서도 마찬가지입니다: 릴리스 노트 (5 페이지), 구성 방법 (9 페이지), 빠른 설치 매뉴얼 (12 페이지)

페이지 인쇄
Allied Telesis AT-9800 Series 방법
Configuring your Allied Telesis Device
Before starting, ensure that your PC has a version of rp-pppoe.
If rp-pppoe isn't on your PC, do one of the following;
•
Download it from
compile and install it.
•
Use the prepackaged installer, for example RPM or deb.
!
add user=linux_client pass=password
set user=linux_client telnet=no ipaddr=192.168.0.1
#
# PPP templates configuration
#
create ppp template=1
set ppp template=1 bap=off authentication=chap
#
# PPP configuration
#
add ppp acservice=test template=1 vlan=1
ena ppp accessconcentrator
#
# IP configuration
#
enable ip
add ip int=vlan1 ip=192.168.0.254

Network diagram

Linux PC (client)
Set Up PPPoE Between a Linux Client and an Allied Telesis Access Concentrator
http://www.roaringpenguin.com/penguin/open_source_rp-pppoe.php
Configure your Allied Telesis device as follows:
netmask=255.255.255.255
eth 1
port 1
Allied Telesis switch
(Access Concentrator)
, then
2