Avtech AVI311 빠른 매뉴얼 - 페이지 6

{카테고리_이름} Avtech AVI311에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech AVI311 14 페이지. Network camera series
Avtech AVI311에 대해서도 마찬가지입니다: 빠른 매뉴얼 (11 페이지)

페이지 인쇄

3. INSTALLATION

3.1 Install the Hardware (For AVI321)

Before installation, you need the following items before installation:

Bracket (supplied with the bracket sales package)

‧

The accessory packages supplied with the bracket sales package, including:

‧

(1) Wall mounting screws

(2) Wall plugs

(3) Cap

(4) M6 Nylok screws

(5) Spirit level

(6) M4 screw

Power Drill

‧

STEP 1: Attach the camera-mounting base to the PTZ camera.

Put the all the camera connectors through the hole of the camera-mounting base. Align the breach of the

camera-mounting base to the sticker label on the camera, and use two M6 Nylok screws to attach the

camera-mounting base to the camera, as shown in the picture below.

STEP 2: Attach the bracket to the wall.

The bracket is composed of two parts: the upper part and the bottom part. Remove the upper part from the

bottom part of the bracket. Use the four mounting screws and wall plugs to attach the bottom bracket to the wall,

as shown in the picture below.

Use the spirit level supplied with the bracket package to check the surface is horizontal or not. If the surface is

horizontal, the bubble will remain in the center circle of the spirit level.

-5-

INSTALLATION