Avtech DGC5205T 사용자 설명서 - 페이지 3

{카테고리_이름} Avtech DGC5205T에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech DGC5205T 4 페이지. Hd cctv total solution, 5mp ir dome camera

INSTALLATION

Step1: Disassemble the camera case into three parts as illustrated in Figure 1.

Step2: Locate the base on the place you would like to install the camera; make sure the cable can be arranged

properly in the base. (Refer to Figure 2)

Step3: Drill 4 holes and screw the base to the wall (or ceiling).

Step4: Put together the bracket and the lens, and slightly adjust the camera lens. Make sure it faces your target

surveillance area.

NOTE: Do not install the lens opposite down. (Refer to

Step 5: Screw the base tight. (Refer to Figure 6)

Figure 3

Step 6: Power on the camera and check the viewing angle.

Figure 6

CONNECTION

1. DC12V Input Terminal

Connect the power terminal of the camera to a DC 12V regulated power supply.

Note:

Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power tolerance of

this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this unit.

2. Video Output Connector (VIDEO OUT)

Connect the camera video output to the video input of a DVR with 75Ω coaxial cable.

Note:

To ensure the camera has sufficient protection against moisture, an extra waterproof measure, such

as by using an insulating tape, must be used to cover the power and video connectors after

connection.

Figure 1

Put together

Figure 4

Figure5

)

Figure 2

Upside

Downside

Figure 5