Dell 5530 Mono Laser 빠른 참조 매뉴얼

{카테고리_이름} Dell 5530 Mono Laser에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell 5530 Mono Laser 2 페이지. Loading paper and specialty media
Dell 5530 Mono Laser에 대해서도 마찬가지입니다: 서비스 매뉴얼 (46 페이지), 설정 및 사양 매뉴얼 (29 페이지), 설정 및 사양 (29 페이지)

페이지 인쇄

Laser Printer

Quick Reference

Loading paper and

specialty media

Loading the 250-sheet or

550-sheet tray

Pull the tray out.

Note: Do not remove trays while a job prints or while Busy

appears on the display. Doing so may cause a jam.

Squeeze the width guide tab inward as shown, and move the

width guide to the correct position for the paper size being

loaded.

Unlock the length guide, squeeze the length guide tab inward

as shown, and slide the guide to the correct position for the

paper size being loaded.

Notes:

Use the size indicators on the bottom of the tray to help

•

position the guides.

For standard paper sizes, lock the length guide.

•

Flex the sheets back and forth to loosen them, and then fan

them. Do not fold or crease the paper. Straighten the edges on

a level surface.

Load the paper.

For single-sided printing, load the paper print side

•

facedown with the leading edge of the paper toward the

front of the tray.

Note: For print jobs using an optional StapleSmart

Finisher, place the leading edge of the paper toward the

back of the tray.

For two-sided or duplex printing, load the paper faceup

•

with the leading edge of the paper toward the back of the

tray.

Note: For print jobs using an optional StapleSmart II

Finisher, place the leading edge of the paper toward the

front of the tray.

Note: Notice the maximum fill line on the side of the tray

which indicates the maximum height for loading paper. Do

not overload the tray.

If necessary, adjust the paper guides to lightly touch the sides

of the stack, and lock the length guide for the paper sizes

indicated on the tray.

Insert the tray.

If a different type of paper was loaded than the type previously

loaded in the tray, then change the Paper Type setting for the

tray from the printer control panel.