Dell D15S 설정 및 사양 매뉴얼 - 페이지 26
{카테고리_이름} Dell D15S에 대한 설정 및 사양 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell D15S 37 페이지. Small form factor
Dell D15S에 대해서도 마찬가지입니다: 설정 및 사양 (39 페이지), 설정 및 사양 매뉴얼 (23 페이지), 설정 및 사양 (34 페이지), 설정 및 사양 (21 페이지), 설정 및 사양 매뉴얼 (38 페이지)
페이지 인쇄
System information
Table 21. System Configuration
Option
Integrated NIC
SATA Operation
Drives
Smart Reporting
USB Configuration
Front USB Configuration
Rear USB Configuration
Audio
Dust Filter Maintenance
26
System setup
Description
Allows you to control the onboard LAN controller. The option 'Enable UEFI Network Stack' is not
selected by default. The options are:
•
Disabled
•
Enabled
•
Enabled w/PXE (default)
NOTE:
Depending on the computer and its installed devices, the items that are listed
in this section may or may not appear.
Allows you to configure the operating mode of the integrated hard drive controller.
•
Disabled = The SATA controllers are hidden
•
AHCI = SATA is configured for AHCI mode
•
RAID ON = SATA is configured to support RAID mode (selected by default)
Allows you to enable or disable the various drives onboard:
•
SATA-0 (enabled by default)
•
M.2 PCIe SSD-0 (enabled by default)
This field controls whether hard-drive errors for integrated drives are reported during system
startup. The Enable Smart Reporting option is disabled by default.
Allows you to enable or disable the integrated USB controller for:
•
Enable USB Boot Support
•
Enable Front USB Ports
•
Enable Rear USB Ports
All the options are enabled by default.
Allows you to enable or disable the front USB ports. All the ports are enabled by default.
Allows you to enable or disable the back USB ports. All the ports are enabled by default.
Allows you to enable or disable the integrated audio controller. The option Enable Audio is selected
by default.
•
Enable Microphone
•
Enable Internal Speaker
Both the options are selected by default.
Allows you to enable or disable BIOS messages for maintaining the optional dust filter that is installed
in your computer. BIOS will generate a pre-boot reminder to clean or replace the dust filter based on
the interval set. The option Disabled is selected by default.
•
Disabled
•
15 days
•
30 days
•
60 days
•
90 days
•
120 days
•
150 days
•
180 days