Dell D15S 설정 및 사양 - 페이지 32
{카테고리_이름} Dell D15S에 대한 설정 및 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell D15S 39 페이지. Small form factor
Dell D15S에 대해서도 마찬가지입니다: 설정 및 사양 매뉴얼 (37 페이지), 설정 및 사양 매뉴얼 (23 페이지), 설정 및 사양 (34 페이지), 설정 및 사양 (21 페이지), 설정 및 사양 매뉴얼 (38 페이지)
페이지 인쇄
Power management
Table 33. Power Management
Option
AC Recovery
Enable Intel Speed Shift
Technology
Auto On Time
Deep Sleep Control
USB Wake Support
Wake on LAN/WWAN
Block Sleep
Post behavior
Table 34. POST Behavior
Option
Adapter Warnings
Numlock LED
Keyboard Errors
Fast Boot
32
System setup
Description
Determines how the system responds when AC power is re-applied after a power loss. You
can set the AC Recovery to:
● Power Off
● Power On
● Last Power State
This option is Power Off by default.
Allows you to enable or disable Intel Speed Shift Technology support. The option Enable
Intel Speed Shift Technology is set by default.
Sets time to automatically turn on the computer. Time is kept in standard 12-hour format
(hour:minutes:seconds). Change the startup time by typing the values in the time and
AM/PM fields.
NOTE:
This feature does not work if you turn off your computer using the switch on a
power strip or surge protector or if Auto Power is set to disabled.
Allows you to define the controls when Deep Sleep is enabled.
● Disabled
● Enabled in S5 only
● Enabled in S4 and S5
.
Allows you to enable the USB devices to wake the computer from standby mode. The option
"Enable USB Wake Support" is selected by default
This option allows the computer to power up from the off state when triggered by a special
LAN signal. This feature only works when the computer is connected to AC power supply.
● Disabled - Does not allows the system to power on by special LAN signals when it
receives a wake-up signal from the LAN or wireless LAN.
● LAN or WLAN - Allows the system to be powered on by special LAN or wireless LAN
signals.
● LAN Only - Allows the system to be powered on by special LAN signals.
● LAN with PXE Boot - A wakeup packet sent to the system in either the S4 or S5 state,
that will cause the system to wake-up and immediately boot to PXE.
● WLAN Only - Allows the system to be powered on by special WLAN signals.
This option is Disabled by default.
Allows you to block entering to sleep (S3 state) in OS environment. This option is disabled by
default.
Description
This option lets you choose whether the system displays warning messages when you use
certain power adapters. This option is enabled by default.
Allows you to enable or disable the Numlock feature when your computer starts. This option
is enabled by default.
Allows you to enable or disable the keyboard error reporting when the computer starts. The
option Enable Keyboard Error Detection is enabled by default.
This option can speed up the boot process by bypassing some compatibility steps: