Dell D18M 소유자 매뉴얼 - 페이지 26
{카테고리_이름} Dell D18M에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell D18M 45 페이지. Remote power switch
Dell D18M에 대해서도 마찬가지입니다: 설정 및 사양 (39 페이지), 설정 및 사양 매뉴얼 (39 페이지), 설치 매뉴얼 (11 페이지)
페이지 인쇄
Power LED light status
Diagnostic error messages
Table 2. Diagnostic error messages
Error messages
AUXILIARY DEVICE FAILURE
BAD COMMAND OR FILE NAME
CACHE DISABLED DUE TO FAILURE
CD DRIVE CONTROLLER FAILURE
DATA ERROR
DECREASING AVAILABLE MEMORY
DISK C: FAILED INITIALIZATION
DRIVE NOT READY
ERROR READING PCMCIA CARD
EXTENDED MEMORY SIZE HAS CHANGED
THE FILE BEING COPIED IS TOO LARGE FOR THE
DESTINATION DRIVE
A FILENAME CANNOT CONTAIN ANY OF THE FOLLOWING
CHARACTERS: \ / : * ? " < > | -
GATE A20 FAILURE
GENERAL FAILURE
HARD-DISK DRIVE CONFIGURATION ERROR
Possible cause
Description
The touchpad or external mouse may be faulty. For an
external mouse, check the cable connection. Enable the
Pointing Device option in the System Setup program.
Ensure that you have spelled the command correctly, put
spaces in the proper place, and used the correct path name.
The primary cache internal to the microprocessor has failed.
Contact
Dell.
The optical drive does not respond to commands from the
computer.
The hard drive cannot read the data.
One or more memory modules may be faulty or improperly
seated. Reinstall the memory modules or, if necessary,
replace them.
The hard drive failed initialization. Run the hard drive tests in
Dell Diagnostics.
The operation requires a hard drive in the bay before it can
continue. Install a hard drive in the hard drive bay.
The computer cannot identify the ExpressCard. Reinsert the
card or try another card.
The amount of memory recorded in non-volatile memory
(NVRAM) does not match the memory module installed in the
computer. Restart the computer. If the error appears again,
Contact Dell
The file that you are trying to copy is too large to fit on the
disk, or the disk is full. Try copying the file to a different disk or
use a larger capacity disk.
Do not use these characters in filenames.
A memory module may be loose. Reinstall the memory
module or, if necessary, replace it.
The operating system is unable to carry out the command.
The message is usually followed by specific information. For
example, Printer out of paper. Take the
appropriate action.
The computer cannot identify the drive type. Shut down the
computer, remove the hard drive, and boot the computer
from an optical drive. Then, shut down the computer, reinstall
Troubleshooting your computer
Troubleshooting steps
•
If the display is connected
and turned on, listen for a
beep code.
26