DGSI TR-976 매뉴얼 - 페이지 2

{카테고리_이름} DGSI TR-976에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DGSI TR-976 2 페이지. Srx-r pumps

Internal foam packaging

3. Now remove the pump body by simultaneously twisting the valve assembly

and pulling at the same time until the pump and the body easily separate.

4. Once separated, remove the upper-and-lower protective foam packaging.

Note: This packaging is provided to protect both the float and control rod from

damage during shipping. DGSI recommends that you save this packaging as

well as the box for any future shipping requirements.

To reassemble the pump, follow the above steps in reverse order. When

installing the bottom plug, it is recommended that you stand the pump upside-

down on the discharge hose-barb, then tighten the two bolts to pull the O-ring

seals into place.

Additional drawings and parts lists can be found at www.DGSI.info

Note: Some parts

listed are sold

only as a kit.

Maintenance

To clean the internal components

of the pump, remove the housing

as outlined in steps 1 – 3 in Packing

and Unpacking, then remove the

cotter and clevis pins from the

bottom assembly before sliding

the "T" assembly from the center

discharge tube.

The control rod and

float can now be

removed for

cleaning. Remove

the barbed fittings to

clean the exhaust

and air-inlet valves

from any debris.

To reassemble the pump, follow the above steps in reverse order.

Warning: Any further disassembly should be carried out by DGSI.