Dell Inspiron 1011 서비스 매뉴얼 - 페이지 24
{카테고리_이름} Dell Inspiron 1011에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 1011 43 페이지. Service manual
Dell Inspiron 1011에 대해서도 마찬가지입니다: 서비스 매뉴얼 (43 페이지)
페이지 인쇄
Back to Contents Page
Memory
Dell™ Inspiron™ 1011 Service Manual
Removing the Memory Module
Replacing the Memory Module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
NOTE:
Memory modules purchased from Dell™ are covered under your computer warranty.
Your computer has one user-accessible SODIMM socket.
Removing the Memory Module
1. Follow the instructions in
Before You
2. Follow the instructions from
CAUTION:
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
4. Remove the memory module from the memory module connector.
1
memory module connector
3
memory module
Replacing the Memory Module
1. Align the notch in the memory module with the tab in the memory module connector.
2. Slide the module firmly into the slot at a 45-degree angle, and press the memory module down until it clicks into place. If you do not hear the click,
remove the memory module and reinstall it.
NOTE:
If the memory module is not installed properly, the computer may not boot.
Begin.
step 2
to
step 10
in
Removing the System
2
securing clips (2)
Removing the
Board.
Battery) before working inside the