Dell Inspiron 1090 서비스 매뉴얼 - 페이지 25
{카테고리_이름} Dell Inspiron 1090에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 1090 47 페이지.
Dell Inspiron 1090에 대해서도 마찬가지입니다: 서비스 매뉴얼 (47 페이지)
페이지 인쇄
Back to Contents Page
Processor Fan and Heat-Sink Assembly
Dell™ Inspiron™ 1090 Service Manual
Removing the Processor Fan and Heat-Sink Assembly
Replacing the Processor Fan and Heat-Sink Assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
If you remove the processor fan and heat-sink assembly from the computer when the heat sink is hot, do not touch the metal housing
of the processor fan and heat-sink assembly.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Processor Fan and Heat-Sink Assembly
1. Follow the instructions in
Before You
2. Remove the label door (see
3. Remove the keyboard (see
4. Remove the palm-rest assembly (see
5. Remove the battery (see
Removing the
6. Remove the memory module (see
7. Disconnect the processor fan and heat-sink assembly cable from the connector on the system board.
8. In sequential order (indicated on the processor heat-sink), loosen the three captive screws that secure the processor fan and heat-sink assembly to the
system board.
9. Lift the processor fan and heat-sink assembly off the system board.
1
processor fan and heat-sink assembly
3
processor fan and heat-sink assembly cable
Replacing the Processor Fan and Heat-Sink Assembly
NOTE:
The original thermal grease can be reused if the original processor fan and heat-sink assembly is reinstalled. If the processor fan and heat-sink
assembly is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved.
Begin.
Removing the Label
Door).
Removing the
Keyboard).
Removing the Palm-Rest
Battery).
Removing the Memory
Module).
2
captive screws (3)
Removing the
Assembly).
Battery) before working inside the